Watlow EZ-ZONE ST - Manual (Page 61)

Watlow EZ-ZONE ® ST • 59 • Chapter 6 Factory Page
Chapter 6: Factory Pages
6
Control Module Factory Page Parameters
To go to the Factory Page from the Home Page, press
and hold both the Advance ‰ and Infinity ˆ keys for
six seconds.
• Press the Advance Key ‰ to move through the
parameter prompts.
• Press the Up ¿ or Down ¯ keys to change the
parameter value.
• Press the Infinity Key ˆ to return to the Home
Page.
Calculating the Modbus Register
The tables below list only the register of the first in-
stance of each parameter. To find the register of the
other instances, use the formula: instance (n) regis-
ter = instance 1 register + ((n - 1) * offset).
Note:
Some of these menus and parameters may not appear,
depending on the modules options. See model number
information in the Appendix for more information.
If there is only one instance of a menu, no submenus
will appear.
[CUSt]
[FCty]
Custom Setup Menu
[```1] to [``20]
[CUSt] Custom Setup
[`par] Parameter
[`iid] Instance ID
[`LoC]
[FCty]
Security Setting Menu
[`LoC] Security Setting
[LoC;o] Operations Page
[LoC;P] Profiling Page
[pas;e] Password Enable
[RloC]
Read Lock
[SLoC] Write Security
[loC;l] Locked Access Level
[roll] Rolling Password
[pas;u] User Password
[pas;a] Administrator Password
*[ULoC]
[FCty]
Security Setting Menu
[`LoC] Security Setting
[CoDE] Public Key
[pass] Password
[diAg]
[FCty]
Diagnostics Menu
[diAg] Diagnostics
[``Pn] Part Number
[`rEu] Software Revision
[S;bld] Software Build Number
[``Sn] Serial Number
[dAtE] Date of Manufacture
[`CAL]
[FCty]
Calibration Menu
[```1]
[`ACt]
Calibration 1 (to 4)
[`Mu] Electrical Measurement
[ELi;o] Electrical Input Offset
[ELi;S] Electrical Input Slope
[ELo;o] Electrical Output Offset
[ELo;S] Electrical Output Slope
* Visible only when Password En-
able found in the Loc menu is
turned on.