Watlow EZ-ZONE ST - Manual (Page 16)

Watlow EZ-ZONE ® ST • 14 • Chapter 2 Install and Wire
Mounting and Dismounting the Controller from a DIN Rail
To mount the controller on a DIN rail, first
hook the top flange on the back of the heat
sink on to the top of the DIN rail. Then
rotate the controller to an upright position
until the lower flange snaps into place.
To dismount the controller, first use a
screwdriver to pull down the small le-
ver on the bottom of the heat sink and
rotate the bottom of the controller for-
ward. Then lift the the controller off of
the rail.
Note:
Typically, the DIN rail is mounted before com-
ponents are mounted on it .
Installation