beautypg.com

Watlow CAS User Manual

Page 22

background image

12 CAS User’s Guide

Installation

1.

Place the TB-50 where you will mount it and use a pencil to trace
around the standoffs.

2.

Drill and tap #6-32 holes in the locations you marked.

3.

Place the TB-50 where you will mount it. Insert the #6 screws in the
standoffs and tighten them.

NOTE

Save the cable tie wraps, ribbon cable, and ribbon cable clamps.
You'll use them when you wire outputs to the TB-50 and when you
connect the ribbon cable.

WARNING

Do not connect power to the CAS now. Test the unit first, as
explained in the Power Wiring and System Test section.