Proface FP3900 - 19 Flat Panel" - Manual (Page 159)

FP3000 Series User Manual
9-14
9.3.3 FP-3650T Series
„Replacing CA5-BLU12XGA-01
(1) Turn the FP unit’s power OFF (i.e. disconnect the FP unit’s power cord). Remove the three (3) I/F cov-
ers, and use a Phillips screwdriver to remove the case’s seven (7) rear attachment screws and USB
holder. Pivot the rear cover open, starting from the top of the unit.
(2) The cover is fastened at the bottom, and hinges open.
(3) Loosen the three (3) circuit board attachment screws.
• Be sure not to break the rear cover’s four (4) alignment tabs when you open it.
• To prevent FP unit damage, be sure the FP unit’s rear cover open/close direction
is correct.
USB holders
Attachment Screws
Attachment
Screws