Proface FP3900 - 19 Flat Panel" - Manual (Page 112)

Chapter 5 Installation and Wiring
5-3
„ Creating a Panel Cut
Create the correct sized opening required to install the FP, using the installation dimensions given. The
installation gasket, installation fasteners and attachment screws are all required when installing the FP. Decide
the panel's thickness based on the level of panel strength required.
„Installation Requirements
• For easier maintenance, operation, and improved ventilation, be sure to install the FP at least
100 mm [3.94 in.] away from adjacent structures and other equipment.
SEE FP-3500T Series
„
Panel Cut Dimensions (page4-15)
FP-3600T Series
„
Panel Cut Dimensions (page4-29)
FP-3650T Series
„
Panel Cut Dimensions (page4-42)
FP-3710T Series
„
Panel Cut Dimensions (page4-56)
FP-3900T Series
„
Panel Cut Dimensions (page4-69)
• Check that the installation panel or cabinet’s surface is flat, in good condition and has no jagged
edges. Also, if desired, metal reinforcing strips can be attached to the inside of the panel, near the
Panel Cut, to increase the panel’s strength.
100
[3.94]
Unit: mm
[in.]
Side View
100
[3.94]
100
[3.94]
100
[3.94]
100
[3.94] 100
[3.94]
100
[3.94]
Rear View