1 operation mode setup, 1 operation mode setup -2, 2 6.1 operation mode setup – Proface FP3900 - 19 Flat Panel" User Manual
Page 127
FP3000 Series User Manual
6-2
6.1
Operation Mode Setup
6.1.1
Preset Settings and Adjustments for Dip Switch and Slide Switch
The Dip Switches and Slide Switch are located in the bottom of the FP unit. Only the settings when the power
supply is turned on is effective to the Dip Switches and the Slide Switch. Before operating the Dip Switches
and Slide Switch, be sure to turn off the power.
Loosen the screws of the cover with a Phillips head screwdriver and then remove the cover. After setting the
dip switches and slide switches, reinstall the cover and screws with the screwdriver. The tightening torque for
those screws is 0.5 to 0.6 N•m.
Dip Switches (SW1)
Slide Switch (SW2)
Bottom
Dip Switches (SW1)
Slide Switch (SW2)
Bottom
Dip Switches (SW1)
Slide Switch (SW2)
Bottom
Cover