Proface FP3900 - 19 Flat Panel" - Manual

1
FP-3900T Series
Installation Guide
Package Contents
„ FP unit (1)
„ Installation Guide (1) (this manual)
„ Warning/Caution Information (1)
„ Installation Gasket (1) (attached to the FP
unit)
„ Installation Fasteners (4/set, 3sets)
„ USB Cable Clamp (1)
„AC Power Connector (1) (attached to the
FP unit)
This unit has been carefully packed, with
special attention to quality. However, should
you find anything damaged or missing, please
contact your local FP distributor immediately.
Required software/Reference
manual
The FP-3900T unit needs the following
software for operation. As FP user manual,
provided by PDF media, describes its details,
download the manual below and get the further
information. Visit Pro-face website below and
get both software and reference manual.
(URL:http://www.pro-face.com/otasuke/)
• Software : Mouse Emulation Software
• Manual : FP3000 Series User Manual
• Before you begin to use the touch
panel, you need to adjust (calibrate) it.
• For use of USB for sending touch data,
the number of the calibration point of
mouse emulation software should be
9. (The initial setting is 4.)
If you do not change the setting values,
the touch position may not be accu-
rate, a little off the point.
• If the touch panel coordinates slip, it is
recommended to make calibration
again.
UL/c-UL/CSA Application
Notes
Be aware of the following items when
building the FP into an end-use product:
• The rear face of the FP unit is not a part of
an enclosure. This unit must be used as a
built-in component of an end-use product
that forms a UL/c-UL-compliant enclosure.
• For indoor use only.
• This unit should be installed in the front
face of a metal panel.
• If this unit is installed so as to cool itself
naturally, be sure to install it in a vertical
panel. Also, be sure that the FP unit is
mounted at least 100 mm away from any
adjacent structures or equipment. If these
requirements are not met, the heat gener-
ated by the FP unit’s internal components
may cause the unit to fail to meet UL/c-UL
standard.
• For use on a flat surface of a Type 4X
(Indoor Use Only) and/or Type 12 Enclo-
sure.
• Type 4X (Indoor Use Only) and/or 12
Enclosure, when the hatch for Front USB
Port is secured by screw.
Type 1 Enclosure, when the hatch for Front
USB Port is open.(FP3900-T41-U only)
Caution
Be sure to read the “Warning/Caution
Information” on the attached sheet before
using the product.