Proface FP3900 - 19 Flat Panel" - Manual (Page 14)

13
What is IP65f?
This unit’s protection rating of IP65f is actually a composite code, consisting of the internationally recognized British
“Ingress Protection” standard (BS EN 60529:1992) - “IP65”, and the standard developed by the Japanese Electronics
Manufacturer’s Association (JEM) - “f”. This code is used in this manual to identify a given product’s degree of structural
resistance to a variety of environmental elements and thus, prevent problems or accidents related to the inappropriate use
of a product. The individual meaning of each character of this code is explained below.
IP 6 5 f
(1) (2) (3) (4)
Required Software /Reference Manual
The FP3000 Series unit needs the following software for operation. As the FP user manual, provided by PDF media,
describes its details, download the manual below and get the further information. Visit Pro-face support site below and get
both software and reference manual.
Pro-face support site - Otasuke Pro!
http://www.pro-face.com/otasuke/
• Software: Mouse Emulation Software
• Manual: FP3000 Series User Manual
(1) Designates the type of protection provided.
(2)
Indicates the degree of protection provided to the human body by the unit, and the degree of
protection provided by the unit's front face from particles/dust intrusion into the interior of the
unit. Here, “6” indicates that the unit is completely protected from dust intrusion.
(3)
Indicates the degree of protection provided by the unit’s front face from water intrusion into
the interior of the unit. Here, “5” indicates that the unit is protected from water intrusion from
a direct water jet.
(4)
Indicates the degree of protection provided by the unit’s front face from oil particle intrusion
into the interior of the unit. Here, “f” indicates that the unit is completely protected from oil
intrusion via either oil particles or oil splashes from any direction (to the front panel).
• Before you begin to use the touch panel, you need to adjust (calibrate) it.
If you don't change the setting values, the touch position may not be accurate, a
little off the point.
•
For use of USB for sending touch data, the number of the calibration point of
mouse emulation software should be 9. (The initial setting is 4.)
If you don't change the setting values, the touch position may not be accurate, a
little off the point.
• If the touch panel coordinates slip, it is recommended to make calibration again.