Proface APL3000B - Node Box PC User Manual
Page 9
8
PL with pre-installed OS
1
Connect peripheral devices and wiring
to the PL unit. Connect a USB keyboard
(commercially available).
PL3000 Series Hardware Manual
Installation and Wiring
•
When connecting a Digital FP as a multi-display to the PL3000 series, refer to the fol-
lowing page.
SEE
Connecting a Digital FP as a multi-display to the PL3000 series (page 9)
2
Turn the PL’s power ON.
Set the power switch on the rear of the PL to ON.
3
To change the BIOS settings, go to the
system setting screen. Skip this step
when you use the factory (default)
settings.
2.1 System Setup Screen Operation (page2-2)
4
Set up the pre-installed OS.
5
Install the PL unit.
•
When connecting a Digital FP as a multi-display to the PL3000 series, refer to the following
page and configure the settings.
SEE
Connecting a Digital FP as a multi-display to the PL3000 series (page 9)
• After hardware setup is completed, the OS must be used to create partitions and
format (initialize) the HDD before any data or applications can be saved to the PL
unit drive. For details concerning these procedures, refer to the OS manufacturer’s
instruction manual.
• Whenever you turn the PL unit’s power OFF, wait until the internal HDD stops
spinning (approximately 5 seconds) before turning the power ON again.
• The PL’s hard disk is designed for use with the Windows
®
2000, Windows
®
XP.
Other operating systems do not support this driver software, etc
•
Use of an uninterrupted power supply is recommended to protect your data from accidental
power failures.
An uninterrupted power supply that supports Windows
®
will give you sufficient time to shut
down your system safely by changing into the power supply for the backup in case of a power
failure, and can even be set up to automatically shut down your Windows
®
OS.
The PL unit, however, cannot be used with a 2-Step Inverter Output type uninterrupted power
supply. Be sure the unit is a sine-output type power supply. For details, consult your local UPS
system dealer.
SEE
SEE
SEE