Proface APL3000B - Node Box PC User Manual
Page 102
Chapter 3 PL Monitoring Features
3-41
SSD/CF Status
Selecting [SSD/CF Status] displays the [SSD/CF Status] dialog box, which
allows confirmation of remaining product life.
Remaining product life is calculated according to the number of write
operations made to the SSD, and is displayed as a percentage value with
one decimal place.
•
Monitoring of SSD life is only possible on pre-installed OS type PL units that
have SSD units. PL units do not support monitoring of CF card life.
•
Monitoring of SSD card life is only possible with SSD units that have been
subjected to an operational inspection by Digital Electronics Corporation.
•
When remaining life becomes 0.0%, the alert set in [Alert Action] under [System
Monitor Property] is generated.
When the remaining life reaches 0.0%, replace the SSD unit with a new one.
Buzzer Off
When [Buzzer] is selected for the alert notification method, you can stop the
buzzer by clicking [Buzzer Off].
Reset
When an alert is detected, clicking [Reset] recovers the System Monitor
from the “alert” status.
•
After an alert is resolved, make sure to reset. If reset is not performed, the alert
history remains, which causes the alert to be detected again even if it was
resolved. For alert recovery procedures, refer to the following section:
Minimize
Stores the System Monitor screen in the task tray.
Item
Operation
SEE