Proface APL3000B - Node Box PC User Manual
Page 39
PL3000 Series Reference Manual
2-8
DMI Event Logging
Point the cursor to [DMI Event Logging] and press the [Enter] Key to go to the DMI event logging set-up
screen.
Soft Mirror Status
Point the cursor to [Soft Mirror Status] and press the [Enter] Key to go to the display screen for the soft mirror
status.
Installed O/S
Specifies a type of OS of the unit.
[Other]
Set when using a non-Plug and Play OS.
[Win2K/XP]
Set when using a Plug and Play OS.
Reset Configuration Data
Specifies whether you want to reset the Plug & Play information which is recorded in the Extended System
Configuration Data (ESCD) Block of the CMOS RAM, when the system boots up next time.
[Yes]
Initializes data the next time the system boots up.
Automatically reset to [No] after the data is initialized.
[No]
Does not initialize data.
Even when [Yes] is selected, the selection automatically returns to [No] after the data is initialized.
Large Disk Access Mode
Specifies the access mode. When you use UNIX or NetWare for OS, the setting should be [Other].
[Dos]
Use this setting normally.
[Other]
Use this setting when using Linux, UNIX, or a similar OS.
Local Bus IDE adapter
Specifies whether to use the IDE adapter.
[Enabled]
Uses the Local Bus IDE adapter.
[Disabled]
Does not use the Local Bus IDE adapter.
RAS Reset Port Mask
Specifies whether to enable or disable the RAS Reset Port feature.
[Enabled]
Enables the Mask feature, and disables the RAS Reset Port feature.
[Disabed]
Disables the Mask feature, and enables the RAS Reset Port feature.
Show CMOS Error
Specifies whether to display the CMOS Checksum Error message when the error occurs.
[Enabled]
Shows error message.
[Disabled]
Does not show error message.
The error messages that can be shown/hidden in this setting are as follows:
CMOS Checksum Error
CMOS Battery Failure
SEE
SEE