Proface APL3000B - Node Box PC User Manual
Page 129
PL3000 Series Reference Manual
5-4
The OS
does
not
operate
properly.
When I start the PL
unit, a popup
message saying
"[Battery Unit
Disconnect Error]" is
displayed.
Is a battery unit mounted?
Installing the battery driver to a PL unit without mounting a
battery unit will prevent the OS from operating properly.
To make the OS operate properly, the battery driver must
be uninstalled.
Uninstall Procedure
1. From the Windows [Start] menu, select [Control Panel].
2. Select [Add or Remove Programs].
3. Select [Battery Unit for PL3000 Series] and click
[Delete].
4. A message asking if you are sure you want to remove
the program from your system is displayed. Click [Yes].
5. A dialog box confirming that the uninstall process is
complete is displayed.
6. Click [Finish] to restart the system.
I want to uninstall the
battery driver.
The connected peripheral device
does not work.
Is the power cable connected properly?
Is the peripheral device connected properly?
-> Refer to the manual for the connected device.
Does the device require driver setup?
-> Refer to the manual for the connected device and set
the driver properly.
Did you start the PL unit with a USB device connected?
-> If the PL unit is started while USB memory or another
USB device is connected, the following phenomenon may
occur depending on the device.
• It takes about 1 minute before the OS starts up.
• If the USB device is not recognized, set [Power on
Delay] to [Enable]. This may solve the problem.
The touch panel does not
respond.
You need to install the touch panel driver when you use
the PL with no pre-installed OS.
Problem
Countermeasure and reference page
SEE
PL3000 Series Hardware Manual
“Hardware Installation”
SEE