Proface APL3000B - Node Box PC User Manual
Page 104
Chapter 3 PL Monitoring Features
3-43
• Do not install the battery driver when a battery unit is not mounted; otherwise, the Battery
Unit Disconnected Error will be displayed. To recover the error, the battery driver should be
uninstalled.
For procedure to uninstall the battery driver, refer to the following section.
• Remaining level of battery power supply cannot be monitored.
• The battery unit and driver communicate via COM2 port. From [Integrated Device
Configuration] in the [Advanced] menu on the System Setup Screen, select [I/O
Device Configuration], and set the [COM Port2:] option to [Enable]. (The factory
default setting is [Enable].)
• The system may not enter standby or hibernation mode normally depending on
your applications or other drivers being used.
• When using battery power, the external COM2 port cannot be used.
•
Monitoring of the Battery status is enabled only when a battery is mounted.
•
Battery units cannot be used with pre-installed OS type PL units that have SSD (solid-state
drive) units.
SEE