Proface APL3000B - Node Box PC User Manual
Page 134
Chapter 5 Troubleshooting
5-9
(7)
The [Question] dialog box will appear. Press the [Yes] button. It will be reconfirmed that the data is all
reset to the original values at the time of delivery.
“Proceed with disk restore? Destination drive will be permanently overwritten.”
(8)
The hard disk recovery program will start. After the recovery operation finishes, the Symantec Ghost™
also will finish. When the message “Please turn off computer” displayed, turn off the power of PL.
(9)
Turn on the power of PL again and immediately press the [F2] key to enter the BIOS setup screen.
(10) Press the [F9] key and select [Yes] for [Load default configuration now?] to set the BIOS setting to the
factory setting. Press the [F10] key to save the setting and restart the PL unit.
(11) After the unit restarts, set up your OS.
SEE
• If BIOS does not recognize the boot drive or if there is a hardware malfunction, the
drive cannot be recovered with Symantec Ghost™. In such cases, Pro-face
recommends that you contact your local PL distributor for instructions about drive
recovery or replacement.
• Pro-face does not guarantee the preservation of any data stored on any hard disk/
SSD/CF card if the hard disk/SSD/CF card has an accident, malfunctions or is
damaged in any way. Therefore, the regular backing up of all important data is
strongly recommended.