Maple Systems STEPware-100 - Manual (Page 5)

4. Type a:\setup (substitute b for a if your 3.5-inch drive is configured as the b drive).
5. Choose the OK button.
6. Follow the instructions on your screen.
NOTE:When installation of STEPware-100 is complete, your PC must be restarted before
STEPware-100 will operate correctly.
STEPware-100 Tutorial
Create a Basic STEPware-100 Project
This step walks you through the creation of a basic STEPware-100 project named
SAMPLE.SWR. Once downloaded to the OIT, this basic configuration allows the OIT to
receive and display data sent from the host controller, and to send data entered from the
OIT’s keypad back to the host controller.
1. Start STEPware-100.
2. From the File menu, choose New. The New Project dialog box appears.
3. In the OIT Model drop down list box, select the appropriate OIT model.
NOTE:It is important to select the correct OIT model. STEPware can not transfer a project
from one OIT to another.
4. Choose the Start New Project button. The Configuration Editor dialog box appears.
2 STEP1 Protocol Operation Manual
1010-0096, Rev. 04
OIT Display Settings OIT to Host Communications Settings
OIT Operational Settings