Maple Systems STEPware-100 - Manual (Page 36)

Key Click Setting
This parameter determines whether an audible key click occurs whenever a key is pressed
on the OIT’s keyboard.
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the Key Click Enabled check box.
To modify this parameter in Configuration mode:
1. At KeyClick:, use the OIT’s TOGGLE key to enable or disable the local keyboard.
Refer to the Configuration Mode section in this chapter for more information.
To modify this parameter from the host controller:
1. Use the Keyboard Control control command. Refer to Appendix A: Control
Commands for more information.
Local Setup Setting
This parameter determines whether the OIT allows you to access Configuration mode. If
this parameter is disabled, you will not be able to enter Configuration mode. Since you
must enter Configuration mode to reprogram the OIT, you will not be able to reprogram
the OIT until the host controller sends a Keyboard Control control command enabling
local setup again.
To modify this parameter using STEPware-100:
1. Open the Configuration Editor.
2. In the OIT Operational Settings group box, select the Local Setup Enabled check box.
To modify this parameter in Configuration mode:
1. At Setup Access:, use the OIT’s TOGGLE key to enable or disable local setup. Refer
to the Configuration Mode section in this chapter for more information.
To modify this parameter from the host controller:
1. Use the Keyboard Control control command. Refer to Appendix A: Control
Commands for more information.
Passwords Setting
This parameter determines the five-digit numeric password used to restrict entry into
Configuration mode. Configuration mode is used to change the OIT’s operating
parameters or to download/upload a project to/from STEPware-100.
When attempting to enter Configuration mode, the OIT prompts you to enter the Setup
Password. If the default setting of “00000” has not been changed, you simply press the
OIT’s ENTER key to access Configuration mode. If the setup password has been changed,
you must enter the correct five-digit numeric password to access Configuration mode.
NOTE:If you forget your password, call Maple Systems Technical Support department at
425-486-4477 for help accessing Configuration mode.
OIT Configuration 33
1010-0096, Rev. 04