Vanguard CT-8000 S3 User Manual
Page 79
REV 1 CT-8000 S3 USER’S MANUAL
74
3.3.7. Printing or Viewing Timing Results
Follow the steps below to print or view the timing results after performing a circuit breaker
timing test:
a. After performing a timing test you will be returned to the “START-UP” menu:
Press the
[2]
key (GET RESULTS).
b. The following screen will be displayed:
NOTE
If you are printing the results of a dynamic resistance test, press the
[2]
key
(PLOT FULL CHART),
[3]
key (PLOT EXPANSION), or
[4]
key (PLOT 0 - 200MS)
and then follow the instructions on page 77.
1. PRINT TEST RESULTS
Press the
[1]
key (PRINT TEST RESULTS) to view the test results on the screen or to
print the tabulated test results WITHOUT the graph. The following screen will be
displayed:
Press the
[1]
key (THERMAL PRINTER) to print the tabulated test results on the
built-in thermal printer. The tabulated results will be printed, and you will be
returned to the “START-UP” menu. A typical tabulated results printout is shown in
Figure 27.
SELECT PRINTER
1.
THERMAL PRINTER
2.
DISPLAY RESULTS
1.
PRINT TEST RESULTS
2.
PLOT FULL CHART
3.
PLOT EXPANSION
4.
PLOT 0 - 200MS
1.
TIME BREAKER 09/16/13
2.
GET RESULTS 10:10:10
3.
SAVE/RESTORE
4.
SETUP
5.
DIAGNOSTICS