Vanguard CT-8000 S3 - Manual (Page 49)

REV 1 CT-8000 S3 USER’S MANUAL
44
d. The following screen will be displayed:
Press the
[1]
key (CREATE NEW SETUP).
e. The following screen will be displayed:
Press the [1] key to enter the transducer travel distance per volt using English units (in
inches per degree), or press the [2] key to enter the transducer travel distance per volt
using Metric units (in millimeters per degree).
f. The following screen will be displayed:
Move the transducer to the reference position and press the
[ENTER]
key.
g. The following screen will be displayed:
Move the transducer a known distance and press the [ENTER] key.
MOVE RES ENCODER TO
KNOWN DISTANCE
"ENTER TO CONTINUE"
MOVE RES ENCODER TO
REFERENCE POSITION
"ENTER TO CONTINUE"
RESISTIVE ENCODER:
1.
ENGLISH (IN./DEG)
2. METRIC (MM/DEG)
RESISTIVE ENCODER:
1.
CREATE NEW SETUP
2. LOAD SETUP
3. PRINT SETUP DIR