Vanguard CT-8000 S3 - Manual (Page 111)

REV 1 CT-8000 S3 USER’S MANUAL
106
3.5.3. Printing a Directory of Test Plans Stored in a USB Flash Drive
Follow the steps below to print a directory of all test plans stored in a USB Flash drive:
a. Make sure a USB Flash drive is inserted in the unit's USB Flash drive port ("USB MEM"
port), and then start from the "START-UP" menu:
Press the
[4]
key (SETUP).
b. The following screen will be displayed:
Press the [1] key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the [4] key (TEST PLANS).
d. The following screen will be displayed:
Press the [3] key (PRINT PLAN DIR).
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT PLAN DIR
4. ERASE TEST PLAN
5. SAVE TEST PLAN
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SHOT DESCRIPTION
4. NUMBER OF CHANNELS
5. NEXT PAGE
1. RUN TEST 10/09/13
2. GET RESULTS 15:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS