Vanguard CT-8000 S3 - Manual (Page 46)

CT-8000 S3 USER’S MANUAL REV 1
41
3.2.10. Configuring the Digital Rotary Transducer Settings
A rotary transducer requires the user to enter the defined linear distance in millimeters or
inches per one degree of rotary motion. Follow the steps below to configure the settings for a
digital rotary transducer:
a. Start from the “START-UP” menu:
Press the [4] key (SETUP).
b. The following screen will be displayed:
Press the [2] key (MEASUREMENT UNITS).
c. The following screen will be displayed:
Press the [3] key (ROTARY ENCODER).
d. The following screen will be displayed:
ROTARY ENCODER:
1.
ENGLISH (In./deg)
2. METRIC (mm/deg)
SELECT UNITS:
1.
ENGLISH
2. METRIC
3. ROTARY ENCODER
4. RES ENCODER
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SHOT DESCRIPTION
4. NUMBER OF CHANNELS
5. NEXT PAGE
1. RUN TEST 10/08/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS