Vanguard CT-8000 S3 - Manual (Page 117)

REV 1 CT-8000 S3 USER’S MANUAL
112
3.5.6. Copying a Test Plan to a USB Flash drive
Follow the steps below to copy a test plan from the unit's internal memory to a connected USB
Flash drive:
a. Make sure a USB Flash drive is inserted in the unit's USB Flash drive port ("USB MEM"
port), and then start from the "START-UP" menu:
Press the [4] key (SETUP).
b. The following screen will be displayed:
Press the [1] key (ANALYSIS POINTS).
c. The following screen will be displayed:
Press the [4] key (TEST PLANS).
d. The following screen will be displayed:
Press the
[6]
key (COPY TO THUMB DRIVE).
1. LOAD TEST PLAN
2. PRINT TEST PLAN
3. PRINT PLAN DIR
4. ERASE TEST PLAN
5. SAVE TEST PLAN
6. COPY TO THUMB DRIVE
1. OPEN TIMING
2. CLOSE TIMING
3. PRINT SETTINGS
4. TEST PLANS
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SHOT DESCRIPTION
4. NUMBER OF CHANNELS
5. NEXT PAGE
1. RUN TEST 10/09/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS