Teledyne LeCroy Inspector - Users Manual - Manual (Page 16)

CATC CATC Inspector User’s Manual Version 2.31
12
to the \WINDOWS directory:
•
CLSDECOD.INI USB Device Class decoding initialization
3.2 Running The Software
The CATC Inspector software is a Windows application, and can be run under Windows 3.1,
Windows 95, and Windows NT. To start the program, double-click on the file name (located
with the Explorer or equivalent service), or on the CATC Inspector icon created during the
software installation.
The program will start with the main window active.
4. THE CATC INSPECTOR SOFTWARE
4.1 Getting Started
The CATC Inspector Bus & Protocol Analyzer continuously monitors all USB activity. At the
operator’s discretion, the analyzer will record a snap shot view of the bus traffic. It will store the
data in a file (initially named “data.usb”) on the system hard drive and then display the
information on the screen. Once the information is captured and displayed, it can be viewed and
analyzed using a variety of tools. The data can be stored permanently, and conveniently viewed
on any PC equipped with the CATC Inspector software. A view-only version of the software
permits subsequent viewing without the need for any Inspector hardware.
4.2 The Main Display Window
The CATC Inspector analyzer’s main display incorporates the following set of Windows pull-
down menus:
•
File
•
Setup
•
Record
•
Report
•
View
•
Decode
•
Search
•
Window
•
Help
Clicking on any of these menus will expand it, offering various function selections. Subsequent
sections of this document describe the operation of each menu item.