Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 93)

Getting Started Manual
922157-00 Rev A 85
Shortcut Buttons
You can access the same functions as the ones produced when using the
Signal Display Grid Pop-Up menu just by clicking a trace-descriptor label,
which shows its corresponding dialog. From there, use the shortcut
buttons at the bottom of the dialog to:

Open the Setup dialog for the trace.

Open the Math dialog for the trace.

Open the Measure dialog for the trace.

Annotate the selected trace.
For more information, see the Shortcut Buttons section of Dialog Area (on
page 87).
Annotating Traces
The instrument gives you the ability to add an identifying label, bearing
your own text, to a waveform display:
For each waveform, you can create multiple labels and turn them all on or
all off. Also, you can position them on the waveform by dragging or by
specifying an exact horizontal position.
Touch the waveform you want to annotate right on the display grid, and
then touch Set label... on the pop-up menu.