Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 119)

Getting Started Manual
922157-00 Rev A 111
Vertical
You can access Vertical settings using the front panel Vertical controls, by
selecting Vertical→ Channel Setup... on the menu bar, or by touching the
Channel trace descriptor label. The following screen-shot shows the C1
Vertical dialog on a LabMaster as an example. For each channel, a
corresponding Vertical dialog contains sections with respective controls.
1. Channel Controls (below) let you set up individual channels.
2. Actions for Trace C1 Buttons (on page 114) let you perform certain
actions on the channel, such as Math, Zoom, and Measure actions.
3. Pre-Processing Controls (on page 115) let you set up pre-process
controls, such as cable de-embedding and interpolation.
NOTE: You can turn channels on and off using this dialog, from the front of the
9xxSZi-A Slave Acquisition Module, from the front of the 9xxMZi-A Master
Acquisition Module, or from the LabMaster 9 Zi-A Channel Setup
dialog.
For LabMaster, the additional LabMaster 9 Zi-A Channel Setup (on page
119) and LabMaster 9 Zi-A ChannelSync™ Calibration Dialog (on page 70)
provide even more channel trace controls.
Channel Controls
The individual Channel Controls section of the dialog provides the following
functions for your respective channel:

Channel Inputs - For each channel, you can set the Channel Input to
either Input A (Upper) or Input B (Lower). The Channel Row LED
Indicators display which input is set for each channel.
NOTE : Slave Acquisition Module s indicate alternative, or B channels, on
named LED indicators

Vertical Scale - For each channel, you can set the vertical scale or
sensitivity and choose whether to use fixed or variable gain
adjustment.