Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 183)

Getting Started Manual
922157-00 Rev A 175
6. Touch the newly displayed Trend math function trace label to
change settings on the Trend dialog (located on the Trend tab at the
lower-right side of the screen).
NOTE: Turning off a trace for which trend data is being collected resets the trend.
If it is necessary to continue data collection for the trend, first create a zoom trace
of the channel trace (before turning off the channel trace).
Creating a Track View
1. In the menu bar, touch Measure → Measure Setup....
2. Touch a parameter tab Px and its corresponding dialog is shown.
3. Now, on the dialog, touch inside the Source1 data entry field and
select an input waveform from the pop-up menu.
4. Touch inside the Measure data entry field and select a parameter
from the pop-up menu.
5. Touch the Track button at the bottom of the dialog.
Now, from the Math selection for Track menu, select a math
function location (Fx) on which to store the Track display. The Track
is then shown along with its respective trace descriptor label for the
selected math function.