Horizontal controls – Teledyne LeCroy LabMaster 9Zi-A User Manual
Page 83
![background image](/manuals/353442/83/background.png)
Getting Started Manual
922157-00 Rev A
75
Auto - Press to turn on Auto Trigger mode, which triggers the
oscilloscope after a time-out, even if the trigger conditions are not
met.
Normal - Press to turn on Normal Trigger mode, which triggers the
oscilloscope each time a signal is present that meets the conditions
set for the type of trigger selected.
Single - Press to turn on Single Trigger mode, which arms the
oscilloscope to trigger once (single-shot acquisition) when the input
signal meets the trigger conditions set for the type of trigger
selected. If the scope is already armed, it will force a trigger.
Stop - Press to prevent the scope from triggering on a signal. If you
boot up the instrument with the trigger in Stop mode, a no trace
available message is shown. Press the Trigger A
UTO
front panel
button to display your trace.
Horizontal Controls
NOTE
: Horizontal front panel controls correspond with screen menu selection:
Timebase → Horizontal Setup....
Delay - Press to toggle between a zero horizontal delay value and
the previous horizontal delay value. Turn to change the horizontal
delay value.
Time/Div - Turn to set the time/division of the oscilloscope timebase
(acquisition system).