Teledyne LeCroy LabMaster 9Zi-A - Manual (Page 235)

Getting Started Manual
922157-00 Rev A 227
Miscellaneous
Other Preference setting controls are shown on the Miscellaneous dialog as
follows:
Numbered sections on this dialog correspond with the following
explanations.
1. You can add the Teledyne LeCroy Logo to hardcopies of your grid
display waveforms by marking the Print Teledyne LeCroy Logo
When Printing Grid Area Only checkbox on the Hardcopy section of
the dialog.
2. You can adjust the Dimming and Control Sensitivity of Zoom traces
as follows:

Use the Dimming control to choose select On, Off, and Auto values.
This controls the darkening/shading of waveform areas not part of
the Zoom trace.

Use Control Sensitivity to choose Legacy or Optimized values
3. If you have Serial Data Debug Solutions installed on your
oscilloscope, you can control Annotations being put On Trace (on all
traces) or On Noisy Trace (only on noisy traces).
4. You can shut off the SuperKnob Help flyout menu by un-marking the
SuperKnob Help checkbox on the Other section of the dialog.