Teledyne LeCroy LabMaster 9Zi-A User Manual

Page 113

Getting Started Manual

922157-00 Rev A

105

4. Touch the Enable Timeout checkbox.

5. Touch inside the Timeout data entry control and provide a timeout

value.

NOTE:

Use the sequence mode timeout to automatically interrupt the

sequence acquisition if the timeout value is exceeded without a valid
trigger. The timeout period accounts for instances when a Num Segments
miscount occurs for some reason and the oscilloscope waits indefinitely for
an unforthcoming segment. During that time, no oscilloscope functions are
accessible. By means of a timeout value, however, the acquisition will be
completed, the waveform displayed, and control of the oscilloscope
returned to the user after the timeout has elapsed.

5. Under Display Settings, touch inside the Display mode control, and

select a sequence mode display from the pop-up menu.

6. Touch the S

INGLE

trigger front panel button.

NOTE:

Once a single acquisition has started, you can interrupt the

acquisition at any time by pressing the

INGLE

front panel button a second

time or by pressing the

TOP

front panel button. In this case, the segments

already acquired will be retained in memory.