KB Electronics KBMK-24DF - Manual (Page 28)

28
FUNCTION GROUP 10 – Communication Mode (DIAC Required)
Function
No. Description Range/Code
Factory
Setting
10.00 *
Assigned Communication Station
Number
1 – 247 30
10.01 Communications Watchdog Timer 0000: Disabled 0001: Enabled 0000
10.02 Watchdog Timeout (Seconds) 0.50 – 2.00 0.50
0 0: Stop 1: Run
1 0: Forward 1: Reverse
2 0: N/A 1: Fault Reset
3
0: JOG-LCL/REM Command Off
1: JOG-LCL/REM Command On
4 0: N/A 1: Preset Frequency 1
5 0: N/A 1: Preset Frequency 2
6 0: N/A 1: Preset Frequency 3
7 0: N/A 1: Preset Frequency 4
8 0: N/A 1: Preset Frequency 5
9 0: N/A 1: Preset Frequency 6
10 0: N/A 1: Preset Frequency 7
10.03 Operational Command
11–15 Reserved
──
0 0: Stop 1: Run
1 0: Forward 1: Reverse
2 0: Normal 1: Fault
3
0: JOG-LCL/REM Command Off
1: JOG-LCL/REM Command On
4 0: N/A 1: Preset Frequency 1
5 0: N/A 1: Preset Frequency 2
6 0: N/A 1: Preset Frequency 3
7 0: N/A 1: Preset Frequency 4
8 0: N/A 1: Preset Frequency 5
9 0: N/A 1: Preset Frequency 6
10 0: N/A 1: Preset Frequency 7
11
0: Jog Momentary Mode
1: Jog Latching Mode
12 Reserved
13 0: Local 1:Remote
10.04 Drive Status
14, 15 Reserved
──
00 Normal Operation
01 Short Circuit Trip
02 Current Limit
03 Current Limit Trip
04 Undervoltage Trip
05 Recovered Undervoltage Trip
06 Overvoltage Trip
07 Recovered Overvoltage Trip
08 Stop Mode
09 Flash Error
10 External Fault Trip (IODA)
11 IODA Error
12 Phase Loss Trip
10.05 Drive Status Description
13 Current Source Trip (IODA)
──
10.06 ** Communications Error Count ── ──
10.07 ** Motor Voltage ── ──
10.08 ** Motor Current ── ──
10.09 ** Bus Voltage ── ──
10.10 ** Motor Frequency ── ──
*Functions which can only be changed while the drive is in the Stop Mode.
**Read only.