KB Electronics KBMK-24DF - Manual (Page 17)

17
FIGURE 13
FLOW CHART TO PROGRAM MOTOR CURRENT FROM 3.6 AMPS TO 2.5 AMPS
*The drive's factory setting of Motor Nameplate Current (Function No. 0.01) is 3.6 Amps.
FIGURE 14
FLOW CHART TO PROGRAM SET FREQUENCY FROM 5.00 Hz TO 43.21 Hz (DRIVE IN STOP MODE) *
*If Function No. 2.01 is set to "0000", frequency change requires "ENTER". Throughout this sequence you must
proceed to the next step within 20 seconds, before the "Press Enter Key" step, or the display will revert to "05.00".
The new value will be stored in Function No. 3.00.