KB Electronics KBMM-225D - Manual

KBMM ™
Installation and Operation Manual
Surface Mount Technology
Solid State SCR
DC Motor Speed Controls
J1
L1 A+
F-
ACCEL
DECEL
EN
CONN1
P2
PWR ON
I1
T
B
F+
A-
J2
CL
L2
P3
MAX
P1
MIN
I2
IR CL
for Use with 1/100 – 3 HP, 90 and 180 Volt
Permanent Magnet and Shunt Wound DC Motors*
AC Line Input: 115 and 208/230 Volts, 50/60 Hz
This Manual Covers Models KBMM-125, 225, 225D
Ultra Fast Current Limit Circuit Prevents
Demagnetization in Permanent Magnet Motors
The information contained in this manual is intended to be accurate. However, the manufacturer retains the right
to make changes in design which may not be included herein.
A Plug-In Horsepower Resistor® and AC Line
and Armature Fuses, supplied separately,
must be installed for this product to operate.
*Auxiliary Heat Sink (Part No. 9861) is required
to achieve maximum rating of control. See
Electrical Ratings, Table 1, on page 9.
!
See Safety Warning on page 6.
A COMPLETE LINE OF MOTOR DRIVES
*See page 6
for CE
Information
*
© 2004 KB Electronics, Inc.
(See back cover)
PATENTED
Manufactured
in the USA