KB Electronics KBMK-24DF - Manual (Page 20)

20
9.4 4-DIGIT DISPLAY: The 4-digit display provides readout of drive status, operating parameters, and
faults. See Table 7, for the Digital Readout Codes displayed and their descriptions.
WARNING! Wait at least 1 minute before opening the cover. Be sure the main power switch
or circuit breaker is in the "OFF" position before servicing the drive. Do not depend on the green
Power On LED (ON), located on the drive's PC board, as shown in Figure 4, on page 9, or the
Status LEDs and the 4-Digit Display, located on the front cover, to no longer be illuminated as a
guaranteed power off condition.
TABLE 7
DIGITAL READOUT CODES
Display Description Display Description
Drive Stopped
Indicates that the drive is in the Stop
Mode. Function No. 4.03 set to "0001".
Parameter Changed
Momentarily flashes. Indicates that a
parameter has been successfully
changed.
Function No. Example
A Function No. consists of a Group No.
(digits on left side of the decimal point)
and a Group Code No.
(digits on right side of the decimal point).
Motor Current Display
When the display is set to show Motor
Current, the format will be "XX.XA".
Function No. 4.04 set to "0001".
Motor Voltage Display
When the display is set to show Motor
Voltage, the format will be "XXXu".
Function No. 4.05 set to "0001".
Bus Voltage Display
When the display is set to show Bus
Voltage, the format will be "XXXU".
Function No. 4.06 set to "0001".
Low Voltage Trip
Indicates that the AC line input voltage is
below the Undervoltage Trip Point
specified in Table 3, on page 8.
Low Voltage Recovery
Indicates that a Low Voltage Trip occurred
and the AC line input voltage has returned
to within the operating range specified in
Table 3, on page 8.
Overvoltage Trip
Indicates that the AC line input voltage is
above the Overvoltage Trip Point
specified in Table 3, on page 8.
Overvoltage Recovery
Indicates that an Overvoltage Trip
occurred and the AC line input voltage
has returned to within the operating range
specified in Table 3, on page 8.
Overload Trip (I 2 t Timeout)
Indicates that the motor has been
overloaded for an extended period of time.
External Fault Trip
Indicates that an external fault has
occurred at one of the MFITs of the IODA.
Function Nos. 7.00 – 7.06 set to "0008".
Current Source Trip
Indicates that the current signal output
(from the IODA) has been opened.
Short Circuit Fault
Indicates that the drive detected a short
circuit at the motor (phase-to-phase).
Data Enter Error
Indicates that the drive is in the Program
Mode and a non-valid parameter change
has been attempted.
Keypad Communication Error
Indicates that the keypad failed to initialize
when the drive is powered up. This is an
abnormal condition – contact our Sales
Department.
Flash Memory Error
Indicates that a flash memory error on the
drive has occurred. This is an abnormal
condition – contact our Sales Department.
IODA Error
Indicates that the drive has lost
communication with the IODA.