KB Electronics KBMK-24DF User Manual
Page 18
18
FIGURE 15
FLOW CHART TO PROGRAM ACCEL TIME VALUE FROM 1.5 SECONDS TO 120 SECONDS
*The factory setting of Accel Time (Function No. 3.03) is "1.5" seconds. The minimum setting of Accel is 0.1
seconds, therefore, the left digits must be changed first since an Accel setting of 000.0 is not allowed.
FIGURE 16
FLOW CHART TO PROGRAM THE DRIVE TO DISPLAY MOTOR RPM
*The factory setting of Display Mode (Function No. 4.00) is Frequency ("0000").
This manual is related to the following products:
See also other documents in the category KB Electronics Software:
- KBVF-13 (45 pages)
- KBVF-27 (29 pages)
- KBDF-13 (73 pages)
- KBMA-24D (25 pages)
- KBWA-22D (36 pages)
- KBDA-24D (57 pages)
- KBDA-29 (1P) (57 pages)
- KBDA-24P (57 pages)
- KBAC-24D (28 pages)
- KBAC-29 (1P) (29 pages)
- SIVFR (28 pages)
- DBM Dynamic Braking Module for Single Phase Input Models (4 pages)
- Power On/Off Switch Kit (2 pages)
- IODA, Input/Output Module for use with all KBDA/KBMK Controls (44 pages)
- SIAC, Signal Isolator, installs inside all KBAC Controls (6 pages)
- KBAC/KBDA -24D Power On/Off Switch Kit (1 page)
- KBAC/KBDA-27D Power On/Off Switch Kit (1 page)
- RFAC-24D CE Approved AC Line Filter, installs inside KBAC/KBDA-24D(Class A) (1 page)
- Fittings (KBAC/KBDA Liquid Tight Fittings, 3 x 0.5, 1 x 0.75")" (1 page)
- KBRF-200A CE Approved AC Line Filter for SCR Controls (Class A) (4 pages)
- KBRF-300 CE Approved AC Line Filter (Class B) (8 pages)
- KBTC-125 (1 page)
- KBIC-120 (28 pages)
- KBMM-125 (32 pages)
- KBWD-15 (9 pages)
- KBWS-12 (25 pages)
- KBCC-240D (22 pages)
- KBWT-16 (7 pages)
- KBMG-212D (36 pages)
- KBRG-212D (32 pages)
- KBRG-255 (18 pages)
- KBWM-120 (16 pages)
- KBPC-225D (19 pages)
- KBPI-240D (24 pages)
- KBPW-240D (19 pages)
- KBRC-240D (24 pages)
- KBBC-24M (5 pages)
- Multi Speed Board (16 pages)
- Anti Plug Reversing Module (APRM-PC) w/Switch Kit (for Model 240D Only) (14 pages)
- KBSI-240D KBSI Signal Isolator (16 pages)