KB Electronics KBMK-24DF - Manual (Page 21)

21
9.5 FAULT RECOVERY: The drive monitors many faults. See Function No. 1.05, on page 21, for restarting
the drive after a fault has been cleared. See Section 9.4, on page 20, for the Digital Readout Codes.
See Section 11, on page 29, for descriptions of the Diagnostic LEDs. See Appendix A, on pages 30 –
49, for IODA faults.
Drive Faults: Undervoltage ("–LU–"), Overvoltage ("–OU–"), Short Circuit at the motor (phase-to-phase)
("–SC–"), and I
2 t or I•t Fault ("OL–t").
10 PROGRAMMABLE FUNCTON SUMMARY LIST
All functions have been factory set, as shown in the tables on pages 22 – 28. The Detailed Programmable
Function List (Part No. A42035) is available – contact our Sales Department.
Programming Mode: When the drive is put into the Programming Mode (see Figure 19), a Function No. will be
displayed. A Function No. consists of a Group No. (digits on the left side of the decimal point) and a Group No.
Code (digits on the right side of the decimal point). The digits can be changed using the Up and Down Keys.
The Left Shift Key is used to move the changeable digit.
When the READ Key is pressed, either a Code or Value will be displayed. Codes have specific descriptions.
Values have numeric ranges.
To program multiple drives, the optional DownLoad Module™ (Part No. 9582) can be used to upload the drive
program and facilitate downloading it to multiple drives.
FIGURE 19
FUNCTION NO. DESCRPTION
Function No. which Contains a Value
Function No. which Contains a Code