KB Electronics RFAC-24D CE Approved AC Line Filter, installs inside KBAC/KBDA-24D(Class A) User Manual
Rfac-24, Description, Specifications

Description
The RFAC-24 is used with the KBAC-24D Adjustable Frequency Drive to provide RFI (EMI) suppression. It installs easily onto the
KBAC-24D PC board with quick-connect terminals. The KBAC-24D with the RFAC-24 complies with CE Council Directive
39/336/EEC relating to the Class A Industrial Standard.
Specifications
10 Amps AC Maximum - 230 Volts AC - 50/60 Hz
Operating Temperature Range: 0 - 50 ºC
Frequency Range: 150 kHz - 30 MHz
Leakage to Ground (Earth): 2.0 mA at 250 Volts AC - 50 Hz
Installation Instructions
Install the RFAC-24 onto the four quick-connect terminal of the KBAC-24D PC board
(L1A, L1B, L2A, L2B) as described below. See Safety Warning, on page 2 of the
KBAC-24D Installation and Operating Instructions manual (Part No. A40289).
Note: When installing the RFAC-24, the optional On/Off AC Line Switch (Part No. 9482)
cannot be used.
WARNING! Disconnect the main power when installing this product.
This product complies with all CE directives pertinent at the time of manufacture. Contact the Sales Department for detailed
installation and Declaration of Conformity.
PC
Board
Terminal Removed
Terminal Installed
INSTALLATION INSTRUCTIONS
RFAC-24
Part No. 9507 for Model KBAC-24D
1. To open the front cover of the KBAC-24D,
the four captive panel screws must be
loosened so they are no longer engaged in the
case bottom.
2. Remove the (2) jumper assemblies that
are installed on the L1A & L1B and L2A &
L2B terminals of the KBAC-24D PC
board. Using pliers, gently rock the
female terminals back and fourth
vertically while pulling them
upward. See Figure 1, above.
3. Install the RFAC-24
onto the L1A, L1B, L2A, L2B
terminals of the KBAC-24D.
Wire the ground ring terminal
to the green ground screw located on the
inside enclosure of the KBAC-24D. Note the proper
orientation of the RFAC-24. See Figure 2.
Note: A
ll wirin
g has b
een om
itted fo
r clarit
y.
(Ground Wire)
KB ELECTRONICS, INC.
12095 NW 39th Street, Coral Springs, FL 33065-2516 • (954) 346-4900 • Fax (954) 346-3377
Outside Florida Call Toll Free (800) 221-6570 • E-mail – [email protected]
www.kbelectronics.com
(A42118) – Rev. A – 1/2005
Figure 1 – Jumper Assemblies
Figure 2 – Installation Diagram