IAI America RCP2CR-SS8C - Manual (Page 99)

91
9. Maintenance and Inspection
5) Install a new motor unit and temporarily tighten it with the tension adjusting bolts (hexagon socket-head screws:
M4 × 20, 4 pcs.).
In this condition, loop the reduction belt over the pulleys.
7) Tighten the thin-head screws (M3 × 6, 4 pcs.) using an Allen wrench of 1.5 mm across flats.
6) Pass a looped strong string (or long tie-band) around the motor bracket and pull it with a tension gauge to the
specified tension. In this condition, uniformly tighten the adjusting bolts.
Tension: 8 kgf
Adjusting bolt tightening torque:
323 N·cm (33 kgf·cm)
Tightening torque: 87.2 N·cm (8.90 kgf·cm)