IAI America RCP2CR-SS8C - Manual (Page 66)

58
9. Maintenance and Inspection
9.9 Reduction Belt [Motor Reversing Type]:
SA5R, SA6R, SA7R, SS7R, SS8R, HS8R
9.9.1 Inspecting the Belt
Remove the pulley cover and visually inspect the belt.
Durability of the reduction belt is affected significantly by the operating condition, and there is no standard
guideline as to when the belt should be replaced.
Generally, the belt is designed to withstand several millions of flexing loads.
As a practical guideline, replace the reduction belt when any of the conditions listed below are observed:
‡7KHWHHWKDQGHQGIDFHVRIWKHEHOWKDYHZRUQVLJQLILFDQWO\
‡7KHEHOWKDVVZROOHQGXHWRGHSRVLWVRIRLOHWF
‡&UDFNVDQGRWKHUGDPDJHVDUHIRXQGRQWKHWHHWKRUEDFNRIWKHEHOW
‡7KHEHOWKDVEURNHQ
9.9.2 Applicable Belt
0DQXIDFWXUHU%DQGR&KHPLFDO,QGXVWULHV
0RGHOQXPEHU
605 PPZLGH5XEEHU676FOHDQURRPW\SHVSHFLILFDWLRQ6$56$5
608 PPZLGH3RO\XUHWKDQHUXEEHUVSHFLILFDWLRQ6$5
608 PPZLGH3RO\XUHWKDQHUXEEHUVSHFLILFDWLRQ665
608 PPZLGH3RO\XUHWKDQHUXEEHUVSHFLILFDWLRQ665+65
9.9.3 Adjusting the Belt Tension
Remove the pulley cover and loosen the four tension adjusting bolts. Apply a tensile load to the belt by moving the
motor to the left and tighten the tension adjusting bolts.
ƔSA5R, SA6R
Move the motor cover.
Motor
7HQVLOHORDG
7HQVLRQDGMXVWLQJEROWVSFV
7HQVLRQDGMXVWLQJEROWWLJKWHQLQJWRUTXH
Use an Allen wrench of 2.5mm
across flats.
0RWRUFRYHUDIIL[LQJEROWVSFV