IAI America RCP2CR-SS8C - Manual (Page 55)

47
9. Maintenance and Inspection
9.3 Cleaning
x Clean the exterior as needed.
x Wipe off dirt with a soft cloth.
x Do not use strong compressed air on the actuator as this may force dust into the crevices.
x Do not use petroleum-based solvent on plastic parts or painted surfaces.
x If the unit is badly soiled, apply a neutral detergent or alcohol to a soft cloth, and wipe gently.
9.4 Adjusting the Stainless Sheet
If the actuator stroke is 400 mm or more, check the stainless sheet for slacking, etc., as needed. If the sheet is
found slacked, adjust the stainless sheet.
[For the procedure to adjust the stainless sheet, refer
WR³5HSODFLQJ$GMXVWLQJWKH6WDLQOHVV6KHHW´@