IAI America RCB-101-MW - Manual (Page 22)

17
Clicking (step) will move the axis by one position, while clicking (continuous move) will cause the
axis to move continuously by looping within the block of specified position data.
Clicking again while the axis is moving continuously will stop the axis when it reaches the next position.
Clicking will stop the axis (the axis will start decelerating the moment the button is clicked and continue to
decelerate until it finally stops.)
* If the data loaded from the controller has been changed, write the modified data again to the controller
beforehand.
* While this mode is active, data cannot be entered in the jogging/inching control groups or point data input
area.
Simultaneous movement of multiple axes
Multiple axes simultaneous start button
You can use this button to simultaneously move the selected axes, from among the multiple axes
currently connected by link cables.
Click the multiple axes simultaneous start button in the positioning setting area.
Fig. 5.10 Multiple Axes Simultaneous Start Button
The “Start multiple axes simultaneously” window will open.
Fig. 5.11 Start Multiple Axes Simultaneously Window
Position
Checkbox
Axis number