SecurityMan LCDDVR4 User Manual

Page 39

Sensitivity is use to adjust the sensitivity level of video motion detection (built-in

software driven) on the DVR system. The sensitivity value level can be set to

1, 2, 3, 4, and OFF (system default). The most motion sensitivity level is 1; the

higher the number, the less sensitive the video motion detection which requires

more movements in the image to trigger motion sensor. In the default OFF

position mean the

Motion detection will not be detecting any motion and turn off

Press

Menu/ESC or right click mouse anytime to exit out of Motion Detection

setup menu and back to

Alarm setup menu.

Select

Motion Area from the Motion Detection setup menu to access the

motion area setup window.

Motion Area is use to mask the range of motion

detection area within the camera image. The range of motion detection block

area is limited to one block of any size, multiple motion detection block areas is

not permitted by the system.

To select or highlight motion area of detection using the front panel or RC

(remote control); move the cursor to a desire point in the image, press the

Select/Enter button once, next use the CH2↓/(DOWN) and then CH4→ button

on the front panel or RC to highlight the area of detection (blue film highlight

color), press the

Select/Enter button again to confirm the selection and to

release the cursor from the highlighted block area. Press

Menu/ESC button at

anytime to exit from

Motion Area setup window.

To select or highlight motion detection area using mouse control; click-hold

down the left mouse click at a desire location in the camera image and then

drag the mouse cursor in a down-right directional movement to mask the area

of detection (blue film highlight color). Use right mouse click anywhere in the

Motion Area window to confirm the masking area and exit out from Motion Area.

IMPORTANT NOTE: To start Motion Record; Motion Schedule (page 28),

Sensitivity level and Motion Area must be setup as instructed above.

During Motion Area masking, the CH1↑/(UP) and CH3← button and an

upward/leftward mouse directional movement cannot be use to mask

the motion detection area.