SecurityMan LCDDVR4 - Manual (Page 25)

19
Mouse Connection
Connect the PS/2 mouse to the PS2 MOUSE port of the DVR located in the back
of the DVR. Mouse control is one of the most convenient way of controlling the
DVR, setup and configure the DVR. If mouse is lost or stolen, any PS2 mouse
should be fully compatible with PS2 MOUSE port and DVR.
Power On DVR & HDD Format
Connect the power jack (Input: AC 100~240V, Output: 12VDC 5.0A, positive
inside) into the power socket located in the rear of DVR and then connect the
other end to an electrical outlet. Power on the LCDDVR4 with the power switch
and the DVR will start to boot into dos mode scanning for new hard disk drive.
If new hard drive is detected, it will prompt to configure or format before the
system gets to the user interface window. To proceed and format the new
hard disk drive, press the PLAY button using the remote control or front panel
button. Once disk format is successful the “ Format….OK” will display on screen
to indicate the hard disk has been successfully formatted as illustrated below.
To cancel the formatting process, press the STOP button using the remote
control or front panel button. Formatting only require one time for newly installed
hard drive; any reboot thereafter will skip the format process in the dos boot up
and boots to the user interface screen. To pause in dos boot up, press the STOP
button at anytime.