SecurityMan LCDDVR4 - Manual (Page 21)

15
HARDWARE SETUP
Hard Drive Installation
To install a SATA hard drive into the LCDDVR, please remove the four screws
from the HDD bracket located in the back panel of the DVR (Step 1). Setup
the jumper setting on the SATA hard drive to either 1.5Gb/s or 3Gb/s operation,
prefer to set to 3Gb/s (Step 2). Secure the hard drive to the HDD bracket with
the provided HDD screws (4x). Then connect the Power and Data cable of the
DVR to the SATA hard drive (Step 3). Slips the HDD bracket back into its slot
and secure the bracket with the four screws (blk), as shown below in step 4
and step 5.
External Monitor Installation
Connect the VIDEO OUT (BNC) from the DVR to the video input of an external
monitor for larger screen display or if the built-in LCD monitor fail.
Step 1 Step 2 Step 3
Step 4 Step 5