Ronan X501NET - Manual (Page 45)

Chapter 2 - Interface
X501NET System Configuration Manual © 2008 Ronan Engineering Company 39
Button Action
Pressing the
Main Menu button takes the user to the Main
Menu page.
Pressing the
Restore original values button restores
the last saved values for all parameters on the page. Note: it
does NOT restore the values to original factory settings.
Pressing the
Save button causes the changes made by the
user on the page to be saved (if the user has sufficient access
rights – see section 2.12.3) and then takes the user to the
appropriate results page (see section 2.1.2).
2.11.2 Connections
Up to 4 nodes can be configured.
2.11.2.1 Node Field
The Node field is read-only. It identifies the the row of fields.
2.11.2.2 Protocol Field
Select the Protocol to use for a node:
• Select Disabled if this node is not in use.
• Select TCP to be able to communicate over both LANs and WANs.
• Select UDP if the communication is only over the same LAN as the X501NET and if
broadcast communication if desired (a broadcast address to be used that to communicate
with an unlimited number of X110s attached to the same LAN).
2.11.2.3 IP Address Field
The IP Address field is to the:
• IP Address of the X110 when TCP is selected as the Protocol
• The broadcast address 255.255.255.255 when UDP is selected.
2.11.2.4 Port Field
The default value for the Port field is 4001. Do not change this value.
2.12 Users Page
The Users page allows administrators to allow up to 10 users to access the X501NET
configuration pages and to assign appropriate access rights to each user.