Ronan X501NET - Manual (Page 32)

Chapter 2 - Interface
X501NET System Configuration Manual © 2008 Ronan Engineering Company 26
Button Action
Pressing the
Point List button takes the user to the Point
Status page.
Pressing the
Prev button cause the page to display the
previous point.
Pressing the
Refresh button reloads the page with the
current status of all cards.
Pressing the
Restore original values button restores
the last saved values for all parameters on the page. Note: it
does NOT restore the values to original factory settings.
Pressing the
Save button causes the changes made by the
user on the page to be saved (if the user has sufficient access
rights – see section 2.12.3) and then takes the user to the
appropriate results page (see section 2.1.2).
2.8.2 Point Parameters
All point parameters are displayed on this page.
2.8.2.1 Physical Address Field
The Physical Address field is read-only on this page. This parameter can be changed on the
General
Configuration page or by modifying the configuration file.
2.8.2.2 Current State Field
The Current State field is read-only and represents the point’s status at the time the Point
Points Configuration page was displayed
25
.
2.8.2.3 Logical Address Field
The Logical Address field contains the logical address for the point (see sections 2.6.2.3,
2.6.2.4 and 2.6.2.5 for information on how the logical address is composed).
2.8.2.4 Tag Field
The Tag field contains the name
26
of the point.
25
Note that the state does not stay current and the
Refresh button needs to be pressed to re-
display the page to see what, if any, change has occurred to point status.
26 User defined name of point.