Ronan X501NET - Manual (Page 41)

Chapter 2 - Interface
X501NET System Configuration Manual © 2008 Ronan Engineering Company 35
Button Action
the last saved values for all parameters on the page. Note: it
does NOT restore the values to original factory settings.
Pressing the
Save button causes the changes made by the
user on the page to be saved (if the user has sufficient access
rights – see section 2.12.3) and then takes the user to the
appropriate results page (see section 2.1.2). However,
changes made do not take effect until the X501NET is
rebooted.
2.10.2 Parameters
These parameters are typically set by Ronan. DO NOT CHANGE ANY OF THESE
PARAMETERS UNLESS YOU COMPLETELY UNDERSTAND IEC 60870 AND HOW
CHANGES CAN AFFECT THE ENTIRE SER SYSTEM.
Changes to these parameters do not take effect until the X501NET is rebooted.
The configuration parameters are:
2.10.2.1 Protocol/Disabled Field
The Protocol/Disabled field is a pull-down menu. It should not be changed from its default
value of Profile A.
2.10.2.2 Device ID Field
The Device ID field is a read-only field on this page
32
. This is an integer number by which the
X501NET MULTIPLEXER is identified within the system.
2.10.2.3 Device Name Field
The Device Name field contains the name of the X501NET that is used for display purposes.
2.10.2.4 Device Password Field
The Device Password field contains the password used by the X501NET to login to the
IEC60870 master station
33
.
2.10.2.5 IEC60870 Servers Field
The IEC60870 Servers field can be used to limit the IEC60870 communications between the
X501NET and IEC60870 master station to an IEC60870 master station fixed IP address (or set
of IEC60870 master stations at fixed IP addresses).
32 This field can be changed on the General Configuration page.
33 Also known as the IEC 60870 Producer.