Here is a curve in the alignment of the beams – Gentec-EO Beamage-M2 User Manual
Page 43
Beamage-M
2
User Manual Revision 2.0
43
It is possible that this operation will bring another problem. The Y-ADJ screw can bring the minimum beam waist
position too far on the left like this:
Figure 4-5 Minimum Beam Waist Too Far on the Left
To resolve this problem, please refer to “The minimum beam waist is too far to the left” (4.9). It is possible that
a compromise between the Y-ADJ adjustment and the Z-ADJ may be necessary.
It is also possible that the Y-ADJ movement will bring another problem: bringing beams closer could make them
overlap. To resolve this problem, please refer to the « Overlapping Beams » section (Erreur ! Source du renvoi
introuvable.).
Figure 4-6 Overlap Problem
4.5. There is a curve in the alignment of the beams