Gentec-EO Beamage-M2 - Manual (Page 42)

Beamage-M 2 User Manual Revision 2.0 42
Figure 4-2 Full rotation around the first spot
Then, adjust your setup to place the first spot on the left-hand side of the screen.
Figure 4-3 Adjust Setup to Place the First Spot on the Left-Hand Side of the Screen
4.4. There are less than 10 visible beams
It could be hard sometimes to get a good compromise between obtaining the minimum of 10 beams and a good
range around the minimum beam waist position.
The first thing to do to get more beams is to bring the beams closer together by using the Y-ADJ screw on the
Beamage-M2 module. This screw changes the distance of a mirror and thus affects the number of visible beams.
Figure 4-4 Y-ADJ Screw Alignment to Change the Distance Between the Beams