Gentec-EO Beamage-M2 - Manual (Page 26)

Beamage-M 2 User Manual Revision 2.0 26
5- Click the M2 mode button in the Ribbon and choose the “Real Time” Calibration Mode.
Figure 3-19 Real Time Calibration Mode Selection
This will activate two new tabs on the right-hand side of the user interface. All the settings and results relative to
the M
2 measurement can be found in those new tabs.
6- The M
2
Real Time Calibration Mode Tab :
Figure 3-20 M 2 Calibration Tab for the Real Time Calibration Mode