Pening, Aved, Easurements – Gentec-EO Beamage-M2 User Manual
Page 39: Figure 3-38 open/save file controls figure 3-39 m, Measures tab
Beamage-M
2
User Manual Revision 2.0
39
3.9. Opening Saved M
2
Measurements
At any time after a calibration, an M
2
real time measurement can be saved. Just press Stop Capture and then
Save Current Image to save one measurement or Save All Images in Buffer to save all the measurements in your
buffer (up to 128 measurements).
Figure 3-38 Open/Save File Controls
To open a saved file, simply press Open and select the desired file. If the measurements were taken in the M
2
mode, the software will open the M
2
Measures tab, the 2D Display and the M
2
Curves Display and show all the
results and associated graphics for M
2
measurements for that file.
Figure 3-39 M
2
Measures Tab