Teledyne 9060 - Zirconium oxide flue gas oxygen analyzer - Manual (Page 52)

9060-Zirconia Analyser
44 Fuel #1 ‘S’ Value
45 Fuel #1 ‘M’ Value
Set-up steps 46 to 51 will be skipped automatically if ‘Single Fuel’ is selected in set-up step
39.
46 Fuel #2 ‘A’ Value
47 Fuel #2 ‘H’ Value
48 Fuel #2 ‘O’ Value
49 Fuel #2 ‘N’ Value
50 Fuel #2 ‘S’ Value
51 Fuel #2 ‘M’ Value
52 Purge/Cal Time
53 Automatic Purge
Set-up steps 54 to 56 will be skipped automatically if ‘No’ is selected in set-up step 53.
54 Time between Purges
55 Purge Duration
56 Purge Freeze Time
57 Number of Cal Gases
Set-up steps 58 to 69 may be skipped automatically, depending on the selection in set-up
step 57.
58 Oxygen Content of Cal Gas 1
59 Maximum Acceptable Positive Error Gas 1
60 Maximum Acceptable Negative Error Gas 1
61 Period Between Gas 1 Autocals
62 Duration of Autocal Gas 1
63 Freeze Time Gas 1
64 Oxygen Content Of Cal Gas 2
65 Maximum Acceptable Positive Error Gas 2
66 Maximum Acceptable Negative Error Gas 2
67 Period Between Gas 2 Autocals
68 Duration of Autocal Gas 2
69 Freeze Time Gas 2
70 Process alarm enable
Set-up steps 71 to 78 will be skipped automatically if ‘No’ is selected in set-up step 70.
71 High oxygen alarm level
72 High oxygen alarm delay time
73 Low oxygen alarm level
74 Low oxygen alarm delay time
75 Oxygen Deviation Alarm (2 probes)
76 Oxygen Deviation Alarm Delay (2 probes)
77 Very low oxygen alarm level
78 Very low oxygen alarm delay time
79 Alarm relay number 2 function select
80 Alarm relay number 3 function select
81 Alarm relay number 4 function select